KitchenAid KHMP5 86510 Instrucciones de uso Pagina 1

Instructions for useGBEN

10The electrical connections must comply with current legislation and be made by a suitably qualified professional. • Information on the voltage and

11Note: Refer to the table on page 6 to ensure that the correcttype of injector is fitted.Traditional burners (T)1. Remove the cap (A).2. Remove the b

12To replace the injectors in the special burner:1. Remove the burner ring (C), the screws (B) holding the cover capin place (A) and the cap itself.2.

13Disconnect the hob from power supply andwait until it is cold before carrying outcleaning and/or maintenance work.To keep the hob in perfect conditi

14If the hob is not working properly, work throughthis guide before contacting our Customer CareCentre.Problem: The burner does not ignite or theflame

400010887049Printed in Italyn06/16Whirlpool Europe S.r.l. – Socio UnicoViale G. Borghi, 27 – 21025 Comerio (VA)Phone +39 0332 759111 – Fax +39 0332 75

Product description and symbols 4Control symbols 4Using the burners 4Practical advice on using the hob 5Positioning the pan supports and wok support 5

4To switch on one of the burners:1. Turn the relevant control knob anticlockwiseuntil the indicator is at the maximum flamesymbol .2. Press the contr

5Read these instructions to get the best out ofyour hob.- Use pans with a similar diameter to the burner(see the table on this page)- Use flat-bottome

6If a hood will be installed over the hob, refer to the hood installation instructions to ensure that the cor-rect clearance above the hob is maintain

7To get the most out of your hob, please readthese instructions carefully and keep them forfuture reference.• These instructions are only valid in co

8PackagingThe packaging materials are fully recyclable andmarked with the recycling symbol . Pleasedispose of all packaging responsibly and carefully

9Technical information for the installer• This appliance can be built into a worktop thatis 20–40 mm thick.• If an oven is not being installed below