KitchenAid KHGD5 86510 Instrucciones de uso descargar pdf (Pagina 12)

To replace the injectors in the special burner:

1. Remove the burner ring (C), the screws (B) hol-

ding the cover cap in place (A) and the cap itself.

2. Unscrew the inner injector (D) and the outer

injector (E) using a 7 mm hex key.

3. Replace the injectors.

4. Refit the cover cap, screws and burner ring.

Note: Make sure that:

1. The burner ring (C) is seated correctly on the

burner following replacement.

The minimum flow level is regulated using the tap at the lowest posi-

tion (small flame) .

There is no need to regulate the primary air in the burners.

To ensure the minimum level is properly regulated, remove the con-

trol knob and adjust the screws on the tap as follows:

1. Tighten to decrease the height of the flame 1 (-)

2. Loosen to increase the height of the flame (+);

3. With the burners on, turn the control knobs from the maximum

to the minimum position to check the stability of the flame.

Regulating the minimum flow level of the gas taps

Replacing the injectors in the wok burner

1 2 ... 7 8 9 10 11 12 13 14 15 16

Sin comentarios

KitchenAid KHGD5 86510 Instrucciones de uso Pagina 12