KHGL 9010/B/01Instructions for use

Technical information for the installer• This appliance can be built into a 20mm to40mm thick worktop.• If no oven is to be installed below the hob,

The electrical connections must comply with current legislation and be carried out by a qualified, competent person. • Information on the voltage and

Note: see the description sheet for the model.1. Remove the pan support (A).2. Remove the burners (B).3. Unscrew the injector (C) with a box spanner 7

Always disconnect the hob from the electricalpower supply and wait until it cools beforecleaning and/or doing maintenance work.In order to keep your h

If the hob is not working properly work throughthe this guide before contacting our CustomerCare Centre.The burner does not ignite, or the flame isuns

5019 719 01154Printed in Italyn12/07Whirlpool Europe S.r.l.Viale G. Borghi, 27 - 21025 Comerio (VA)Phone 0332.759111 - Fax 0332.759268www.whirlpool.eu

Product description and symbols 4Using the burners 4Practical advice on using the hob 5Positioning the pan supports and Wok pan adapter 6Installation

1. Central removable pan support2. Removable side pan support3. Auxiliary burner4. Semi-fast burner5. Fast burner6. Semi-fast burner7. Professional

Read these instructions to get the best from yourhob: - Use pans with a diameter suitable for the burneryou are using ( see table opposite) - Only use

To facilitate positioning of the pan supports on the hob, it is recommended to start by fitting the centralpan support (1).Place the central pan suppo

If a hood is installed above the hob, read the instructions for fitting the hood where it indicates the correctdistances to be complied with.Installat

To get the most out of your hob, please readthe instructions carefully and keep them forfuture consultation.• These instructions are only valid in th

PackingThe packing material is 100% recyclable and islabelled with the recycling symbol . Pleasedispose of all packing responsibly and carefully.Prod