KitchenAid KHIP3 90400 Instrucciones de uso descargar pdf (Pagina 10)

After unpacking the product, check that it has not been damaged during transit.

In case of problems, contact your dealer or our after-sales service.

See the illustrations on page 5 for the appliance’s dimensions when built in

and for installation instructions.

PREPARING THE CABINET FOR FITTING

- Install a separator panel under the hob.

- The lower part of the product must not be accessible after

installation.

- If there is an oven beneath the hob, do not install the separator

panel.

• Observe the clearances between the underside of the appliance and

the separator panel below it given in the figure.

• Failure to observe the minimum clearance between the hob and the

top of the unit (min. 5 mm) may prevent the product from working

correctly.

• If an oven is installed beneath the hob, make sure it has a cooling

system.

• Do not install the hob above a dishwasher or washing machine, as its electronic circuitry could

become damaged by steam and humidity.

• If flush mounting the product, call our after-sales service to fit the set of screws (4801 211 00112).

• To remove the hob, use a screwdriver (not provided) to prise off the perimeter clips on the underside

of the appliance.

WARNING

min 5 mm

min 20 mm

min 5 mm

Installation

- Disconnect the appliance from the power supply.

- Installation must be carried out by qualified personnel who are familiar with current safety

and installation regulations.

- The manufacturer cannot be held responsible for injury to persons or animals and for damage

to property resulting from failure to observe the regulations provided in this section.

- The power supply cable must be long enough to allow the hob to be removed from the

worktop.

- Make sure the voltage specified on the rating plate on the underside of the appliance is the

same as that of the domestic electricity supply.

WARNING

Electrical wiring

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Sin comentarios

KitchenAid KHIP3 90400 Instrucciones de uso Pagina 10